[In-Stock] White Trim JUMBO Drop Spindles

This listing is for ready to ship White trim JUMBO drop spindles with MATTE rings; if the core colour that you'd like does not show up in the menu, it is not in stock and can be purchased from the [Made-to-order Custom Trim JUMBO Drop Spindles] listing. If you prefer a holographic ring, they are also available via that same link.

Each drop spindle comes with:

1x   textured mystery wool mini-batt(approx.14g/0.5oz)
2x   ¼” black rubber ring for bobbins

Please note that drop spindles do not come with bobbins as they can be used without one. However, up to 4 bobbins can be bundled with a drop spindle for the discounted rate of $9 each.

Select a ½” hook (same as reg. size spindle hook) if you'll be spinning or plying yarn that isn't 'bulky' OR a ¾” Hook if you are planning on spinning or plying yarn that is 'bulky' or thicker. A 1/2" hook is big enough to ply 4 'worsted weight' yarn strands. Hooks are not interchangeable - you can size up, but not size down.

The free textured mystery colour wool mini-batt(approx.14g or 1/2oz) is for you to play around with, and test out on your new spindle. In the menu above, you can choose to upgrade to a 56g/2oz mystery batt or to completely remove it should you not want it.

Specs

3d printed with PLA+ trim and bobbins, with PLA whorl cores. Unfinished hardwood dowels. Metal ½” cup hook.

Drop Spindles
Dowel length: 24.8cm / 9 3/4"
Dowel thickness: 9.5mm / ⅜”
Total length: 27.9cm or 11”
Diameter: 10.2cm / 4”
Hook: ½” Hook (same as reg. size spindle hook) OR ¾” Hook (Bulky Yarn)
Note* Hooks are not interchangeable
Weight: 66g / 2.3oz

Bobbins
Length: 12.7cm / 5"
Diameter: 8.3cm / 3 1/4"
Weight: 13g / 0.46oz
Fits any 3/8” diameter dowel

Drop Spindle & Bobbin total weight: 79g / 2.79oz

Care Instructions/Warnings

Whorl & bobbins are made of  PLA(A renewable plastic made from plant starch). This material begins to warp at 60°c/140°F.

The hardwood shaft is unfinished, and you may choose to paint it or seal it with a wood finish of your choice. If the bobbins are snug, please sand down the wood prior to finishing or they may not fit afterwards.

I recommend practicing over carpet or grass as drop spindles and bobbins in general can be damaged from any drop on a hard surface – especially if they are full of yarn, as that will increase their weight. 

Due to the printing process, bobbins can snap if bent or if dropped.